quality Waste paper pulper manufacturers, which includes a pulping pool, the top of the pulping pool is open, bearing seats are respectively arranged on the two opposite side walls of the pulping pool, bearings are arranged in the bearing seats, the bearings are rotatably connected to the rotating shaft, and the rotating shaft is spaced along the axial direction A plurality of cutter discs are arranged, the cutter discs are fixedly connected with the rotating shaft through two cross-shaped webs, a plurality of rib plates are arranged at intervals along the circumferential direction between the cutter discs, and the outer circumference of the cutter discs are inclined and arranged with a plurality of same rotation directions. The inclination direction of the knife teeth is consistent with the rotation direction of the rotating shaft. One end of the rotating shaft extends out of the pulping tank to connect with the large gear. The motor and the gear reducer fixed on the support frame on the outer wall of the pulping tank are connected by a belt to form a belt. Transmission, the output shaft of the reducer is connected to a pinion gear, and the pinion gear meshes with the large gear to form a gear transmission. The waste paper is subjected to the cutting force of the cutter teeth, so that the pulp at the bottom rises under the force, so the pulp It will be stirred and cut to refine again, making the beating effect better.

The above is a brief introduction to the relevant knowledge about quality Waste paper pulper manufacturers.